This popped up on my Facebook and I thought I'd share in case anyone is looking for a printer. This is the printer I have. It's a Prusa or Ender3 clone and although it has it's quirks like most entry level printers, it works very well. There are a few differences though. It does not run Merlin, but it still uses standard Gcode. You can't use a glass bed since the proximity sensor doesn't detect it. I replaced the stock bed with a magnetic spring steel one and it works great. Everything sticks and pops off when cool.
It's a great price at $100 off.
https://www.amazon.ca/TRONXY-255X260MM- ... 251&sr=8-6
Bruce
3D Printer
-
the-mailman
- Posts: 308
- Joined: Fri Aug 22, 2014 8:07 pm
- Location: Hammonds Plains
3D Printer
MAAC: 19887
I never crash, I just create exciting ways to meet the ground. After all, take-offs are desirable, landings are inevitable.
I never crash, I just create exciting ways to meet the ground. After all, take-offs are desirable, landings are inevitable.