SOLD * - SHAFT 480 - receiver ready reduced to 120.00
Posted: Thu Jan 28, 2021 6:04 pm
S-O-L-D..! The SHAFT 480 is a laser-cut balsa kit produced by STEVENS-AERO of Colorado.
My build thread is located here: viewtopic.php?f=20&t=5285&p=25719&hilit ... aft#p25719
Wing was recovered due to a small Boo-Boo..! This is a light-weight airframe with a generous wing area, so it loves a calm morning wind..!
Wingspan is about 50 inches
Motor is a Cobra 2820-14 (840Kv)
ESC is 40 amp
Servos are Hitec HS85BB on Rudder and Elevator and Emax 9154 on each Aileron
Prop is 12/6 APCe
Runs on 3S-2200 or 4S-1800
Price is $180.00 receiver ready.
My build thread is located here: viewtopic.php?f=20&t=5285&p=25719&hilit ... aft#p25719
Wing was recovered due to a small Boo-Boo..! This is a light-weight airframe with a generous wing area, so it loves a calm morning wind..!
Wingspan is about 50 inches
Motor is a Cobra 2820-14 (840Kv)
ESC is 40 amp
Servos are Hitec HS85BB on Rudder and Elevator and Emax 9154 on each Aileron
Prop is 12/6 APCe
Runs on 3S-2200 or 4S-1800
Price is $180.00 receiver ready.