Teach-In from the Tx:
1. With the battery disconnected from the receiver, and the transmitter turned on, move the throttle slide to full throttle position. Leave it in this position and then connect the battery to the receiver.
2. Wait for 2 seconds, and you will hear one long tone to indicate the receiver is connected.
3. You will next hear a series of short tones to indicate the current cutoff setting.
- 1 beep = 5.6V (6–7-cell Ni-MH )
2 beep = 6.0V (8–9-cell Ni-MH, 2-cell Li-Po)
3 beep = 9.0V (3-cell Li-Po)
7 beep = 70% Smart Cut soft cutoff
5. Once you have entered the programming mode, the programming menu will give the following selections:
- 1 beep = menu item1 = 5.6V (6–7-cell Ni-MH )
2 beep = menu item2 = 6.0V (8–9-cell Ni-MH, 2-cell Li-Po)
3 beep = menu item3 = 9.0V (3-cell Li-Po)
7 beep = menu item4 = 70% Smart Cut soft cutoff
You will then hear 4 short beeps indicating that a successful selection has been made. Note: If the slider is left in the full throttle position and upon reaching selection 4, no selection has been made, the programming menu will repeat. You may also scroll through the menu in reverse by moving the throttle slide to the full down position during any 4-second pause.
6. Move the throttle slide to idle. The receiver has now armed the motor, and when you move the slide upward, the motor will run.