Toughen Foam with ProBond

A place to learn more about Electric RC Flying.

Toughen Foam with ProBond

New postby retiredVTT on Fri Oct 16, 2015 2:18 pm

http://elmers.com/product/detail/e7501

Here is something I read today that might be of interest..how to strengthen foam with a glue product from ELMER's.

If you want to improve the colors on your Splendor and make it more hangar rash resistant, and strengthen areas subject to wear... without adding weight...use Elmer's PROBOND Advanced. I paint the nose area, leading edges and the hatch with it with a small paint brush. It goes on with a gray-blue color but dries crystal clear. It really enhances the colors and does toughen the foam. I do the same on my CZ Cub and Rare Bear



Bill
Bill
HEFA #5
MAAC #13708
User avatar
retiredVTT
 
Posts: 4950
Joined: Wed Oct 01, 2008 9:59 pm
Location: Bedford, NS

Re: Toughen Foam with ProBond

New postby bdg on Sun Oct 18, 2015 9:21 pm

I picked up a small bottle today.... I will try it out on some of my belly landers and perhaps water planes in preparation for flying from the snow..... brrr.....

I will report back on how well this works....

Brian
User avatar
bdg
 
Posts: 565
Joined: Mon Mar 12, 2012 11:59 am


Return to HEFA "RC University"

Who is online

Users browsing this forum: No registered users and 1 guest

cron